MENU ☰
SCENARIO 02 · FREIGHT

The freight bill that was decided by a packing choice, not a shipping rate

Two identical units can ship at very different cost per piece. The difference is not the carrier or the rate; it is whether the unit travels as a box of air or as a flat pack with a fixing bag.

Illustrative procurement scenario. This is not a customer case, and no outcome or performance figure is claimed.

Tiered clear acrylic bakery display stand
Owner-supplied product photograph. It shows the format under discussion, not the unit described in the scenario.

The situation

A tiered unit is quoted with the finished assembly as the shipping unit. The unit is stable, the sample is approved, and the per-piece price is agreed. The freight quote arrives and the volumetric weight is several times the actual weight, because an assembled tiered display is mostly empty space inside a large carton.

The unit is fine. The way it travels is what the buyer is paying for.

The two routes and what each one costs

Neither route is cheaper in every case. They move cost between three places: the carton, the store, and the damage risk.

  • Assembled: fewer parts to lose, faster to place, but a large carton and a high volumetric weight
  • Knocked down: a small carton and much lower freight per unit, but labelled parts, a fixing pack and assembly instructions
  • Either route: protective film and interleaving, because a scuffed panel is unsellable whether or not it was assembled

Where knocked-down goes wrong

A flat pack fails when the parts are not identifiable or the fixing pack is short. A store team with a deadline will not chase a missing screw; the unit goes back in the carton and the rollout slips.

The fix is procedural rather than structural: every part labelled to match a one-page drawing, the fixing pack counted and sealed per carton, and the instruction showing the order of assembly rather than only the finished unit. None of that is expensive. All of it is decided before production.

How to choose

Ask what the carton volume is per unit in each route, then compare that against the freight mode and the store's ability to assemble. For a multi-store rollout the assembly question is usually the deciding one, not the freight: a small saving per unit is worthless if a store cannot build the fixture.

The pack-out can be estimated before a quotation using unit and carton dimensions, and confirmed on a sample once the structure is fixed.

Send this in the RFQ

  • Destination country, shipping mode and whether the goods go to one warehouse or many stores
  • Whether the store team can assemble, and whether a technician is available
  • Any carton weight limit set by your retailer or forwarder
  • Whether cartons must be marked by store or by SKU
REQUEST A QUOTE →